New South Wales Consolidated Regulations

MID-WESTERN REGIONAL LOCAL ENVIRONMENTAL PLAN 2012 - REG 4.1D

4.1D Minimum lot sizes for certain split zones

(1) The objectives of this clause are as follows--

(a) to provide for the subdivision of lots that are within more than one zone but cannot be subdivided under clause 4.1,

(b) to ensure that the subdivision occurs in a manner that promotes suitable land use and development.

(2) This clause applies to each lot (an
"original lot" ) that contains--

(a) land in Zone RU5 Village, Zone R1 General Residential, Zone R2 Low Density Residential or Zone R3 Medium Density Residential, and

(b) land in Zone RU1 Primary Production, Zone RU4 Primary Production Small Lots or Zone C3 Environmental Management.

(3) Despite clause 4.1, development consent may be granted to subdivide an original lot to create other lots (the
"resulting lots" ) if--

(a) one of the resulting lots will contain--

(i) land in Zone RU5 Village, Zone R1 General Residential, Zone R2 Low Density Residential or Zone R3 Medium Density Residential that has an area that is not less than the minimum size shown on the Lot Size Map in relation to that land, and

(ii) all of the land in Zone RU1 Primary Production, Zone RU4 Primary Production Small Lots or Zone C3 Environmental Management that was in the original lot, and

(b) all other resulting lots will contain land that has an area that is not less than the minimum size shown on the Lot Size Map in relation to that land.

(4) A dwelling cannot be located on the part of a resulting lot referred to in subclause (3) (a) (ii).